No-tag-added Don’t add VLAN tag for this untagged-port Next you need to configure the interface for which you would like to analyse the traffic.ĪSW-C01(eth-4/3)# monitor all both mirror 1 Has the remote switch been configured (y/n)? y The destination switch must be configured before proceeding. Truncation Enable truncation for Remote mirroring. IP-ADDR Remote mirroring UDP encapsulation destination ip addr.ĪSW-C01(config)# mirror 1 remote ip 172.18.9.2 10999 172.18.11.233 Remote mirroring UDP encapsulation port.ĪSW-C01(config)# mirror 1 remote ip 172.18.9.2 10999 Ip Remote mirroring destination configuration.ĪSW-C01(config)# mirror 1 remote ip 172.18.9.2 Remote Remote mirroring destination configuration. Port Mirroring destination monitoring port. In this case the switch is using IP adres 172.18.9.3 with source port UDP/10999 and the remote host has IP adres 172.18.11.233.Įndpoint Remote mirroring destination configuration. Use the following commands to create a monitor session to a remote host. When the remote host is running WireShark, the monitored traffic can be analysed on the remote host.įirst you need to configure the switch to send a copy of the traffic to a remote host. You also have the option to send the monitor traffic to a remote switch or even to a remote host. AOS switches have the option to monitor / copy traffic from port A to port B.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |